Bulldog-BT1100

Good evening.

Seems like my dash oil and fuel warning lights have died. They should appear for few seconds when power is turned ON? Nothing! I checked the manual and it states they're LED bulbs. Are they changable?
Last time i was running low on petrol, fuel warning light came on, but it was sort of flickering and faint..

Is the oil sensor measuring pressure or level?

Any advice what to do next?
Cheers.

Some update.

I located both oil/fuel sensor wires under the seat near battery. Tested both by disconnecting wires. Still no lights at the dash. Then I used small steel wire stick it to the lead and put the other end to ground and had both oil and fuel lights illuminate!

For what I can tell I need to change both sensors! Almost hoped more for a burnt bulb. Anyone done the fuel sensor? Is it doable without removing tank alltogether? Never lifted tank since I've had this bike only 2 months. Oil sensor seems bit more straightforward. Probably routing the wire is biggest concern there.

As far as I remember both are float sensors and quite expensive.
Try to remove them and try to check/clean the floating device. Also check for "unbroken" wiring and clean contacts, i.e. almost zero Ohms resistance.

Good luck!

I did oil change and reset that * message from the dash, and guess what. Now I have both oil and fuel warning lights working again!

Luckily I did not invested in any parts yet!