Ok I give up…… Please forgive me if this seem like a stupid question -How do I remove the right-hand side panel to access the rear brake reservoir? As far as I can see it looks like the tail section needs to be removed to gain access to the rear *, is this correct??
Thanks
Krock
Side panel removal
-
Topic author - Beiträge: 25
- Registriert: Sonntag 5. Januar 2014, 17:11
Side panel removal
I'm dyslexic you aerosol.
-
- Beiträge: 18
- Registriert: Donnerstag 25. Dezember 2014, 13:01
- Vorname: Brian
Re: Side panel removal
Hi Krock.
Yes, you have to remove the tail piece to get to the * that holds the top rear of the side panel to the frame. You can then lift the side panel up and off the two pegs that hold the bottom of the panel.
However, I managed to top-up the rear brake reservoir without removing the side panel by un-screwing the cap and easing it out of the gap at the top of the frame, then topping up the reservoir with a small funnel, and a lot of care!
Biggles
Yes, you have to remove the tail piece to get to the * that holds the top rear of the side panel to the frame. You can then lift the side panel up and off the two pegs that hold the bottom of the panel.
However, I managed to top-up the rear brake reservoir without removing the side panel by un-screwing the cap and easing it out of the gap at the top of the frame, then topping up the reservoir with a small funnel, and a lot of care!
Biggles
-
Topic author - Beiträge: 25
- Registriert: Sonntag 5. Januar 2014, 17:11
Re: Side panel removal
Thanks Biggles. Looks like 4 screws and a bolt to remove the tail section is that right?
Cheers
Krock
Cheers
Krock
I'm dyslexic you aerosol.
-
- Beiträge: 18
- Registriert: Donnerstag 25. Dezember 2014, 13:01
- Vorname: Brian
Re: Side panel removal
Sounds about right. It is a while since I last did it.
Biggles
Biggles