Side panel removal

whatever you want to say about the technology

Topic author
Krock
Beiträge: 25
Registriert: Sonntag 5. Januar 2014, 17:11

Side panel removal

Beitrag von Krock »

Ok I give up…… Please forgive me if this seem like a stupid question :oops: :oops: -How do I remove the right-hand side panel to access the rear brake reservoir? As far as I can see it looks like the tail section needs to be removed to gain access to the rear *, is this correct?? :roll: :roll:

Thanks

Krock
I'm dyslexic you aerosol.

Capt_Biggles
Beiträge: 18
Registriert: Donnerstag 25. Dezember 2014, 13:01
Vorname: Brian

Re: Side panel removal

Beitrag von Capt_Biggles »

Hi Krock.

Yes, you have to remove the tail piece to get to the * that holds the top rear of the side panel to the frame. You can then lift the side panel up and off the two pegs that hold the bottom of the panel.

However, I managed to top-up the rear brake reservoir without removing the side panel by un-screwing the cap and easing it out of the gap at the top of the frame, then topping up the reservoir with a small funnel, and a lot of care!

Biggles

Topic author
Krock
Beiträge: 25
Registriert: Sonntag 5. Januar 2014, 17:11

Re: Side panel removal

Beitrag von Krock »

Thanks Biggles. Looks like 4 screws and a bolt to remove the tail section is that right?

Cheers

Krock
I'm dyslexic you aerosol.

Capt_Biggles
Beiträge: 18
Registriert: Donnerstag 25. Dezember 2014, 13:01
Vorname: Brian

Re: Side panel removal

Beitrag von Capt_Biggles »

Sounds about right. It is a while since I last did it.

Biggles
Antworten